Fitting a silencer

UK specification

All Models

All models are fitted with an integral, full length moderator. An additional screw-in adaptor will need to be purchased to allow the fitting of an additional ½ inch UNF threaded silencer. The fitting of an aditional silencer will not alter the power of your rifle, it may however change the point of impact.

Fitting

  • 1. Unscrew the knurled thread protector on the end of the rifle.
  • 2. Screw on the additional silencer - do not over-tighten.
You do not appear to have (at least) the Flash 7 plugin installed - you can find it here here or at the Adobe website http://www.adobe.com/products/flashplayer/ if you are on a mac or can't install the .exe file from the disc

Note: The thread size is 1/2inch UNF which is a common sze used on most airgun silencers.

To fit an additional silencer

  • 1. Unscrew the knurled thread protector on the end of the rifle.
  • 2. Screw on the additional silencer - do not over-tighten, the end plug will start to unscrew.

Air Ranger & Air Wolf

The rifle is fitted with an integral, full length moderator. An additional screw-in adaptor will need to be purchased to allow the fitting of an additional ½ inch UNF threaded silencer.

USA specification

All rifles are fitted with a non removable integral silencer. The aditional screw-in adaptor is included with US specification rifles, however due to Federal silencer regulations, additional removable silencers should not be fitted to these rifles.

Maintenance & modification